Carbide cutter cone blue Fréza pro NailArt
Hard metal milling cutter cone blue.
| Category: | Accessories for NailArt |
|---|---|
| EAN: | 4779050640387 |
Carbide Wolfram Cutter - medium coarse
Carbide ( carbide) cutter designed for professional use only.
Thanks to the fine cutting edges, the cutter is suitable for gentle removal of old modelling and for adjusting the final shape
The simple cross-cut blade allows you to conveniently remove gel, polyacrylic and acrylic modelling in a short time at the recommended speed.
This cutter is designed for right-handed users only due to its single-sided cutter.
Cutter with high durability.
Shank diameter- 2,35 mm
Blade length- 14mm
Blade diameter - 6,0mm
Proper use of rotary tools (cutters) for manicure:
Warning! Observe the max. speed! 15- max. 30 rpm
For each rotary tool it is necessary not to exceed the maximum speed specified by the manufacturer.
Exceeding the maximum speed will damage the clamping mechanism!
Too much pressure on the cutter overloads the micromotor in your grinder, the clamping device in the hand piece, but also the cutters. Therefore, insert the cutters sensitively into the chuck and work carefully without too much pressure. The cutters thus become less clogged and the grinding ability is not reduced. After grinding it is necessary to clean the milling machine from dirt mechanically with a dust brush (with a special metal cleaning brush if necessary - you can also find it in the offer) and sterilise and disinfect with products intended for metal tools.
The sterilization temperature during hot air sterilization must not exceed 180°C.
Exceeding this temperature leads to a loss of hardness and thus a reduction in tool life
