IBX Repair IBX systém regenerace nehtu

IBX® REPAIR

IBX® REPAIR is a targeted professional treatment that shields the natural nail from mechanical damage, levels cracks and surface irregularities, and improves adhesion between the nail plate and polish, gel polish, gel or acrylic. Used with IBX® STRENGTHEN, it enables full restoration of weak or damaged nails.

IBX Repair is intended to be used only in combination with IBX STRENGTHEN! DO NOT USE ALONE!

Uses

• Improves adhesion between natural nail and nail polish / gel polish / gel or acrylic enhancement
• With IBX® STRENGTHEN – treats and restores soft, thin, split or otherwise damaged nails; fills cracks and unevenness
• Helps reduce “white spots” on the nail
• Targeted repair of damaged areas or overall protection before colour and enhancements
• Acts like double-sided tape for split nails – fuses damaged layers together

Content: 7.4 ml

Treatments per bottle: approx. 60–70

Cost per treatment: approx. 1 €

Minimum shelf life: 36 months after opening

Application Steps

A) First Application – complete treatment (REPAIR + STRENGTHEN)

1) Start with IBX® REPAIR

1. Apply a thin layer of IBX REPAIR about 1–2 mm from nail edges. Do not apply to cuticles.
2. Heat cure – blow dryer (40 cm) or 75–100W desk lamp (20 cm) for 1 minute.
3. Wipe nail dry with a lint-free wipe.
4. Cure in UV lamp 2 min, CCFL/LED 1 min.
5. Remove inhibition layer with cleanser.

2) Then IBX® STRENGTHEN – first layer

1. Apply a thin layer of IBX (avoid cuticle).
2. Heat cure for 4 minutes.
3. Wipe nail dry with lint-free wipe.
4. Cure in UV lamp 2 min, CCFL/LED 1 min.
5. Remove inhibition layer with cleanser.

3) IBX® STRENGTHEN – second layer (only at the first visit)

1. Apply a thin layer of IBX, heat cure 2 minutes.
2. Wipe, cure (UV 2 min / CCFL/LED 1 min), remove inhibition layer.

B) Subsequent Applications

1) First IBX® REPAIR

1. Apply a thin layer (avoid cuticles).
2. Heat cure 1 minute.
3. Wipe, cure (UV 2 min / CCFL/LED 1 min), remove inhibition layer.

2) Then IBX® STRENGTHEN – one layer

1. Apply thin layer.
2. Heat cure 2 minutes.
3. Wipe, cure (UV 2 min / CCFL/LED 1 min), remove inhibition layer.

After application, nails are ready for polish, gel polish or further enhancement.

Composition and Safety

All gels, acrylics, liquids and oils by DENATO are registered in the European CPNP portal and manufactured exclusively in the EU or USA.

• Contain no dangerous or prohibited substances.
• Not tested on animals.
• Minimise the risk of allergic reactions.

WARNING:

• For professional use only.
• May cause an allergic reaction.
• Avoid contact with eyes.
• Keep out of reach of children.

To view the Safety Data Sheet, click the button below.